Last Updated on March 24, 2024 by Jawad Ali
Do you know how to repair a leaky drain? We are the Plumbers in Turramurra, and we committed to giving customers the knowledge they need to solve any drainage issues they may have.
If you don’t move immediately to address a water leak, you could waste a lot of water and increase your water bill. We’ve outlined our detailed procedure for successfully fixing a faulty drain below. We sincerely hope you find it instructive and helpful.
First, locate the leak
The best approach to finding the source of a leak is to look for discoloration stains on your home’s ceilings, walls, and floors. These are the areas where leaks are most likely to result in obvious harm. However, keep in mind that a leak’s precise position and origin might not be immediately apparent because it can have originated in one place and moved to another. It is important to look for the reason thoroughly because leaks can occasionally travel a long way before they drain and produce any obvious damage.
Disassemble the drain in Step 2
You are prepared to address the issue after you have located the leak’s source. The plumber’s wrench can be used to disassemble the drain. Before you do this, turn off the water so that you don’t get completely soaked! Make sure to inspect the pipes for corrosion and rust. You will need to obtain a replacement if a pipe has been damaged by corrosion or a crack.
Clean all pieces in Step 3
This step is very important and is frequently missed. After disassembling the complete drain assembly, you must thoroughly clean every component. Before cleaning, place each piece in a bucket of warm, soapy water to soak. When you start to reinstall the pipe parts, any dirt, debris, or putty on them will obstruct the fresh putty and result in another leak. Therefore, it is crucial to properly clean all pipe components.
Reassemble Drain in Step 4
Reinstalling the drain can start when everything has been thoroughly cleaned and dried. Apply a generous layer of plumber’s putty to each connection you have before reinserting the pipe into the fittings.
Do not over-tighten in step 5
People frequently believe that the tighter they make the connection when reassembling the drain, the less probable it is that a leak would occur. However, this is untrue. In actuality, overtightening frequently makes the issue worse. Reassemble the pipes carefully, being mindful not to overtighten them or unintentionally cause any additional leaks.
Test in Step 6
Check that everything functions after putting everything back together. To check for additional leaks, turn on the water and let it flow for a bit. If you discover any, it may be because the putty was not placed properly or the connections were made too tightly. If there are no leaks, on the other hand, congrats—your leaky drain has now been fixed Read more